User Manual

RS-232 INTERFACE 4 - 5
RS-232 Host Parameters (continued)
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS terminal enables the
transmission of code ID characters listed in Table below. These code ID characters are not programmable and
are separate from the Transmit Code ID feature. The Transmit Code ID feature should not be enabled for these
terminals.
NOTE The code types in Table may not be automatically enabled. Check the defaults for each code type in
Table 8-1, Chapter 8, SYMBOLOGIES.
Table 4-3 Terminal Specific Code ID Characters
Code Type ICL Fujitsu
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf
Mode B/
OPOS/JPOS
Olivetti Omron CUTE
UPC-A AAA A A A A
UPC-E EEC C CE None
EAN-8/JAN-8 FF FF B B B FF None
EAN-13/JAN-13 FFA A AF A
Code 39 C <len> None M M M <len> C <len> 3
Code 39 Full ASCII None None M M None None 3
Codabar N <len> None N N N <len> N <len> None
Code 128 L <len> None K K K <len> L <len> 5
I 2 of 5 I <len> None I I I <len> I <len> 1
Code 93 None None L L L <len> None None
D 2 of 5 H <len> None H H H <len> H <len> 2
GS1-128 L <len> None P P P <len> L <len> 5
MSI None None O O O <len> None None
Bookland EAN FFA A AF None
Trioptic None None None None None None None
Code 11 None None None None None None None
IATA H<len> None H H H <len> H <len> 2
Code 32 None None None None None None None
GS1 DataBar
Variants
None None E E None None None