User Manual

STANDARD DEFAULT PARAMETERS A - 3
Caps Lock On N/A Disable 6-7
Convert Wedge Data N/A No Convert 6-8
Caps Lock Override N/A Disable 6-7
Function Key Mapping N/A Disable 6-8
FN1 Substitution N/A Disable 6-9
Send and Make Break N/A Send 6-9
User Preferences
Set Defaults All Defaults 7-4
Out Of Box Experience N/A N/A 7-5
Report Version N/A N/A 7-6
Parameter Bar Code Scanning 236 Enable 7-7
Beep After Good Decode 56 Enable 7-7
Direct Decode Indicator 859 Disable 7-8
Suppress Power-up Beeps 721 Do Not Suppress 7-8
Beeper Tone 145 Medium 7-9
Beeper Volume 140 High 7-10
Beeper Duration 628 Medium 7-11
Hand-Held Trigger Mode 138 Standard (Level) 7-12
Hands-Free Trigger Mode 630 Enable 7-13
Power Mode 128 Continuous On 7-14
Time Delay to Low Power Mode 146 1 hour 7-15
Continuous Bar Code Read 649 Disable 7-17
Unique Bar Code Reporting 723 Enable 7-17
Decode Session Timeout 136 3.0 sec 7-18
Time-out Between Same Symbol 137 0.6 sec 7-19
Time-out Between Different Symbols 144 0.2 sec 7-19
Miscellaneous Options
Transmit Code ID Character 45 None 7-20
Prefix Value 99, 105 7013 <CR><LF> 7-21
Table A-1 Standard Default Parameters Table (Continued)
Parameter
Parameter
Number
Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.