User Manual

7 - 24 LS2208 Product Reference Guide
FN1 Substitution Values
Key Category Parameter # 103
Decimal Value Parameter # 109
Keyboard wedge and USB HID keyboard hosts support a FN1 Substitution feature. Enabling this substitutes
any FN1 character (0x1b) in an EAN128 bar code with a value. This value defaults to 7013 (Enter key).
When using host commands to set the FN1 substitution value, set the key category parameter to 1, then set
the 3-digit keystroke value. See the ASCII Character Set table for the current host interface for the desired
value.
To select a FN1 substitution value via bar code menus:
1. Scan the bar code below.
2. Locate the keystroke desired for FN1 Substitution in the ASCII Character Set table for the current host
interface. Enter the 4-digit ASCII Value by scanning each digit in Appendix E, NUMERIC BAR CODES.
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for USB HID keyboard, scan the Enable FN1 Substitution bar code on page 3-10.
To enable FN1 Substitution for Wedge, scan the Enable Keyboard Wedge FN1 Substitution bar code on
page 6-9.
Scan Data Transmission Format (continued)
<PREFIX> <DATA> <SUFFIX 2>
(6)
<PREFIX> <DATA> <SUFFIX 1> <SUFFIX 2>
(7)
Set FN1 Substitution Value