User Manual

7 - 18 LS2208 Product Reference Guide
Decode Session Timeout
Parameter # 136
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next scan two bar codes from Appendix E,
NUMERIC BAR CODES that correspond to the desired on time. Include a leading zero for single digit
numbers. For example, to set a timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes; to set a timeout of 9.5 seconds, scan the bar code below, then scan the 9 and 5 bar codes. To change
the selection or cancel an incorrect entry, scan Cancel on page E-3.
Decode Session Timeout
(Default: 3.0 sec)