Specifications

21
Windows Driver
Properties
8/6/2010 KR203 Software Integrator Guide P1028248-001 Rev. A
size (e.g. if 58mm x 200mm Roll Paper is selected, the print will be 200mm long in
Page Mode).
When media tracking is set to variable, the driver will shorten the print to only contain
the imaged document. The driver will end the print after the last printed element (text,
barcode, or graphic) then send a feed, cut, and eject command. The page length may
vary from page to page but will always be a minimum of 92mm.
When mark sensing is set, the driver will send the page size to the printer, the printer
will restrict the print to the area between the black marks. If the printed area is larger
than the space between the black marks, it will print additional pages (receipts).
The margin values in the receipt application must be corrected after setting the driver
values. If the margin in the application is set to 9mm and the driver is set to 2mm, the
application setting will be enforced unless the driver is changed accordingly.
Compression sets whether the data is sent to the printer compressed or
uncompressed. If the data is sent uncompressed, this may result in longer print times.
However, depending on the complexity of the image, compressed data may not
significantly reduce print time.
Presenter Settings – Cutter Mode determines how the receipt is cut; Partial Cut Width
sets the width of paper that remains attached in the center of the receipt after a
cut.The range is 0 and 1mm to 60mm. If the range is set to 0 then the receipt will be
cut completely. Partial cut is activated only when “cut per document” is selected - in
other words, when a multi-page document is sent to the printer, each page will receive
a partial cut and a full cut at the end of the document. Note: Partial cut will only work
with Document mode and will be set to 0 otherwise.
Presenter Loop Length determines how much paper is held in the presenter loop.
Eject Length determines how much paper is exposed for the customer. The range is
from 1mm to 600mm with the default set to 50mm. If the eject length is set larger than
the length of the receipt, the printer will retain a portion of the receipt in the presenter
unless the “Clear Presenter” option is set to “Yes”.
Presenter Length Addition is an additional length to compensate for the thickness of
the kiosk wall. The range is from 0 to 255mm with the default set to 0.
Presenter Timeout determines how long the presenter will hold the receipt before
ejecting it. The range for the timeout is from 0 to 300 seconds with the default set at 0.
Clear Presenter determines if a receipt is retained, or if it is ejected after the the
presenter. Clear Presenter should not be used with Page Hold and will be set to No if
Page Hold is selected.
Page Hold determines if individual pages of a multi-page print are held. The driver
shall monitor the presenter to determine if it has cleared before sending the next page.
Page Hold should only be used with Cut per page and will be set to No otherwise.