Specifications

Accessories
Routing Cables with the Large Media Roll Adapter
66
P1028247-001 Rev. B KR203 Hardware Integrator Guide 10/26/2010
Right Side Routing
1. Plug the media roll low sensor into the printer.
2. Secure the wiring to the tie-down points on the large media roll adapter using plastic
cable ties as shown.
3. Route the wiring under and to the outside of the universal roll holder and secure it
using plastic cable ties.
4. Attach the sensor to the roll support using the screw.
Power Cable
Because of the ferrite attached to the power cable accessory, it is necessary to route it so
that it does not interfere with the function of the large media roll adapter.
When using a power source other than the power supply accessory, routing the wiring is
done along the left side of the large media roll adapter using a plastic cable tie at the tie-
down point.
Data Cables
Data cables are routed along the right side of the large media roll adapter. Secure the
cables to the tie-down point on the large media roll adapter using plastic cable ties.