Specifications

15
Windows CE Driver
Printer Settings
3/1/2011 KR203 Windows CE Software Integrator Guide P1028251-001 Rev. A
Top Margin
The Top Margin is the equivalent to the distance between the cutter and the print head and
is by default 12 mm. If it is set between the minimum of 2 mm or 11 mm it will reverse the
paper.
Bottom Margin
The Bottom margin can be set between 0 and 9 mm and will be added to the bottom of the
page in Variable Mode and will limit the printable area in Continuous Mode and Mark
Sensing. The default is 0.
Cutter Mode
Cutter Mode can be set to None, Every Page and Cut at the document end. The default is
Every Page. When set to Every Page and a multi-page document is printed each page will
be cut. If set to Cut at document end and a multi-page document is printed all pages will
print and only one cut at the end of the document will be issued. Partial Cut Width is used
with Cut at document end.
Partial Cut Width
Partial cut leaves multi-page receipts attached at the specified width. The partial cut width
can be set to 0 and between 10 and 60 mm; the default is 0 and it disables partial cut (full
cut). Partial cut can only be used with the Cut at document endselection in Cutter Mode.
Presenter Loop Length
Presenter Loop Length determines how much paper is held in the presenter loop. The
presenter loop length can be set between 0 and 600 mm and the default value is 400 mm.
A setting of 0 disables the presenter loop and media feed directly through the presenter.
Eject Length
Eject Length determines how much paper is exposed for the customer. The range is from
20mm to 600mm with the default set to 50mm. If the eject length is set larger than the
length of the receipt, the printer will retain a portion of the receipt in the presenter unless
the “Clear Presenter” option is set to “Enable”.
Figure 2-5 • Partial Cut Diagram
10 mm
Page 1
Page 2
Page 1
Page 2
Cut
Not Cut
60 mm