User guide

iMZ Series User Guide

Normal Boot-up LED Behavior

1. Press Power (on/off) button for 1.5 seconds until Green

power LED becomes solid.

2. When Power button is released within 1 second, the

Green power LED starts blinking to indicate start of pow-

er-up sequence.

3. Once 1/3 of the total boot-up time has elapsed (approx.

4-5 seconds), the Amber media status LED becomes sol-

id, and the Green power LED continues blinking.

4. Once 2/3 of the total boot-up time has elapsed (approx.

8-10 seconds), the Blue communication LED becomes

solid, the media status LED continues to be solid Amber,

and the Green power LED continues blinking.

5. When the boot-up sequence is successfully complet-

ed, the power LED turns solid Green, the media status

(Amber) and communication (Blue) LEDs turn off.

Note: If continue to hold down the power button without releasing,

the LED will remain illuminated solid green until the power button is

released and the printer will not power on. Only when power button

is pressed for 1.5 seconds and released before 2.5 seconds the printer

will proceed to the power up sequence. This behavior was design to

avoid accidentally power up the printer when the power button is

pressed against an object for long periods of time when carrying the

printer in a bag.

Diagnostic (Two key) Report LED Behavior

1. Press Feed and Power buttons (see Fig. 10) simultane-

ously to activate printing of two key report.

2. Green power LED starts blinking.

3. After 6 seconds the printer prints Zebra logo and the

words “Building Two Key Report”, indicating the user to

wait.

Building Two-Key Report.....