User guide
23
iMZ Series User Guide
Verify the Printer Is Working
Before you connect the printer to your computer, portable
data terminal or wireless LAN, make sure that the printer is in
proper working order. You can do this by printing a configu-
ration label using the “two key reset” method. If you can’t get
this label to print, refer to “Troubleshooting”.
Printing a Conguration Label
1. Press Feed and Power buttons (see Fig. 10) simultane-
ously.
2. Release the Power button after approximately one sec-
ond.
3. Release the Feed button approximately one second after
Green power LED is illuminated.
4. After 6 seconds the printer prints Zebra logo and the
words “Building Two Key Report” indicating the user to
wait.
5. LED lighting sequence replicates the one described in
steps 3) and 4) above while waiting for the two key re-
port to print.
6. Once boot-up time sequence permits the two key report
to start printing, then the two key report prints.
7. Power LED turns solid Green once two key is com-
plete.
Note: Refer to Fig. 18 for details on conguration report content.