Specifications

ZPL Commands
^BJ
70
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
^BJ
Standard 2 of 5 Bar Code
Description The ^BJ command is a discrete, self-checking, continuous numeric
symbology.
With Standard 2 of 5, all of the information is contained in the bars. Two bar widths are
employed in this code, the wide bar measuring three times the width of the narrow bar.
•
^BJ supports a print ratio of 2.0:1 to 3.0:1.
• Field data (
^FD) is limited to the width (or length, if rotated) of the label.
Format ^BJo,h,f,g
This table identifies the parameters for this format:
Important • If additional information about the Standard 2 of 5 bar code is required, go to
www.aimglobal.org.
Parameters Details
o = orientation Accepted Values:
N = normal
R = rotated 90 degrees (clockwise)
I = inverted 180 degrees
B = read from bottom up, 270 degrees
Default Value: current
^FW value
h = bar code height
(in dots)
Accepted Values: 1 to 32000
Default Value: value set by ^BY
f
= print
interpretation
line
Accepted Values:
N = no
Y = yes
Default Value: Y
g = print
interpretation
line above code
Accepted Values:
N = no
Y = yes
Default Value: N