Specifications

Wireless Commands
^WL
334
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
^WL
Set LEAP Parameters
Description Use this command to enable Cisco
®
Lightweight Extensible Authentication
Protocol (LEAP) mode and set parameters. LEAP is user authentication method that is
available with some wireless cards.
Format ^WLa,b,c
The following table identifies the parameters for this format.
Parameters Details
a = mode Accepted Values: OFF, ON
Default Value: OFF
b =user name Default Value: Any 4 to 40 alphanumeric characters user
c = password Default Value: Any 4 to 40 alphanumeric characters password