Specifications

321
RFID Commands
^WV
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
^WV
Verify RFID Encoding Operation
Description Use this command to enable or disable the write verify function. When write
verify is enabled, this command verifies the RFID encoding operation to ensure that the tag
about to be programmed contains the hex data “A5A5” in the first two bytes. This parameter is
not persistent (carried over from label to label).
Format ^WVe
This table identifies the parameters for this format.
Important • This command is not supported by all printers or firmware. See Table 13
on page 287 for the list of printers and firmware with which you can use this command.
Parameters Details
e =enable
Accepted values: Y or N
Default value: N