Specifications

307
RFID Commands
^RS
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
a = signals on applicator
Note • This parameter does not apply to the R2844-Z. For the
R4Mplus, this parameter applies only to printers with firmware version
SP994X (R4Mplus European version).
When the value for parameter
p (read/write position of the transponder) is
nonzero, this parameter changes the number of start and stop print signals
required for printing.
In Single mode, one start print command is required. In Double mode, two are
required, so the printer will resume printing only after the second start print
command is received.
Accepted values:
S = single signal
D = double signal (For the R110PA X 4, Double mode will work only if the
read/write position is changed from the default of zero.)
Default value:
S
c
= certify tag with a
pre-read
Not applicable.
s = void print speed
Note • This parameter does not apply to the R2844-Z. For the
R4Mplus, this parameter applies only to printers with firmware version
SP994X (R4Mplus European version).
If a label is voided, the speed at which “VOID” will be printed across the label.
Accepted values: any valid print speed
Default value: the printer’s maximum print speed
Parameters Details