Specifications

RFID Commands
^RS
306
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
p = read/write position of
the transponder
Sets the read/write position of the transponder in vertical (Y axis) dot rows
from the top of the label. Set to 0 (no movement) if the transponder is already
in the effective area without moving the media.
Important • If a label format specifies a value for this parameter, this
value will be used for the programming position for all labels until a
new position is specified or until the printer is turned off (
O) and then
back on (
I).
Accepted values: 0 to label length
Default value:
For the R110PAX4 and R2844-Z: 0
For all other supported printers: label length minus 1 mm (1/16 in.)
v = length of void
printout
Sets the length of the void printout in vertical (Y axis) dot rows.
Accepted values: 0 to label length
Default value: label length
n = number of labels
The number of labels that will be attempted in case of read/encode failure.
Accepted values: 1 to 10
Default value: 3
e = error handling
If an error persists after the specified number of labels are tried, perform this
error handling action.
Accepted values:
N = No action (printer drops the label format causing the error and moves
to the next queued label)
P = Place printer in Pause mode (label format stays in the queue until the
user cancels)
E = Place printer in Error mode (label format stays in the queue until the
user cancels)
Default value: N
Note • You can set the printer to send an error message to the host for
each failure. To enable or disable this unsolicited error message, refer to
the
^SX and ^SQ ZPL commands. Use V for the condition type for an
RFID error.
Parameters Details