Specifications

273
ZPL Commands
~TA
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
~TA
Tear-off Adjust Position
Description The ~TA command lets you adjust the rest position of the media after a label is
printed, which changes the position at which the label is torn or cut.
Format ~TA###
This table identifies the parameters for this format:
Comments If the parameter is missing or invalid, the command is ignored.
Important • These are some important facts about this command:
• For 600 dpi printers, the step size doubles.
• If the number of characters is less than 3, the command is ignored.
Parameters Details
### = change in
media rest
position
(3-digit value in
dot rows must be
used.)
Accepted Values:
–120 to 120
Default Value: last permanent value saved