Specifications

267
ZPL Commands
^SS
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
^SS
Set Media Sensors
Description The ^SS command is used to change the values for media, web, ribbon, and
label length set during the media calibration process. The media calibration process is
described in your specific printer’s user’s guide.
Format ^SSw,m,r,l,m2,r2,a,b,c
This table identifies the parameters for this format:
Parameters Details
w = web (three-digit
value)
Accepted Values:
000 to 100
Default Value: value shown on the media sensor profile or
configuration label
m = media (three-
digit value)
Accepted Values:
000 to 100
Default Value: value shown on the media sensor profile or
configuration label
r = ribbon (three-
digit value)
Accepted Values:
000 to 100
Default Value: value shown on the media sensor profile or
configuration label
l = label length (in
dots, four-digit
value)
Accepted Values:
0001 to 32000
Default Value: value calculated in the calibration process
m2 = intensity of
media LED
(three-digit
value)
Accepted Values:
000 to 100
Default Value: value calculated in the calibration process
r2 = intensity of
ribbon LED
(three-digit
value)
Accepted Values:
000 to 100
Default Value: value calculated in the calibration process
a = mark sensing
(three-digit
value)
Accepted Values:
000 to 100
Default Value: value calculated in the calibration process
b = mark media
sensing (three-
digit value)
Accepted Values:
000 to 100
Default Value: value calculated in the calibration process
c = mark LED
sensing (three-
digit value)
Accepted Values:
000 to 100
Default Value: value calculated in the calibration process