Specifications

227
ZPL Commands
^MM
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
Cutter — after printing, the media feeds forward and is automatically cut into predetermined
lengths.
Comments Be sure to select the appropriate value for the print mode being used to avoid
unexpected results.
The Delayed Cut feature can be activated as follows:
• through PRINT MODE on the printer’s control panel
•with a ^MMD command
Note • When the printer is in the Delayed Cut PRINT MODE, it will cut the label when it
receives the ~JK (Delayed Cut) command. To activate the ~JK command, the printer's
PRINT MODE must be set to Delayed Cut and there must be a label waiting to be cut.
When the printer is not in the Delayed Cut PRINT MODE, the printer will not cut the label
when it receives the ~JK command.