Specifications

ZPL Commands
^MF
224
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
^MF
Media Feed
Description The ^MF command dictates what happens to the media at power-up and at
head-close after the error clears.
Format ^MFp,h
This table identifies the parameters for this format:
Comments It is important to remember that if you choose the
N setting, the printer assumes
that the media and its position relative to the printhead are the same as before power was
turned off or the printhead was opened. Use the
^JU command to save changes.
Parameters Details
p = feed action at
power-up
Accepted Values:
F = feed to the first web after sensor
C = (see ~JC on page 191 definition)
L = (see ~JL on page 198 definition)
N = no media feed
Default Value: platform-dependent
h = feed action after
closing printhead
Accepted Values:
F = feed to the first web after sensor
C = (see ~JC on page 191 definition)
L = (see ~JL on page 198 definition)
N = no media feed
Default Value: platform-dependent