Specifications

221
ZPL Commands
^LT
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
^LT
Label Top
Description The ^LT command moves the entire label format a maximum of
120 dot rows up or down from its current position, in relation to the top edge of the label. A
negative value moves the format towards the top of the label; a positive value moves the
format away from the top of the label.
This command can be used to fine-tune the position of the finished label without having to
change any of the existing parameters.
Format ^LTx
This table identifies the parameters for this format:
Comments The Accepted Value range for
x might be smaller depending on the printer
platform.
The
^LT command does not change the media rest position.
Important • For some printer models, it is possible to request a negative value large enough
to cause the media to backup into the printer and become unthreaded from the platen. This
condition can result in a printer error or unpredictable results.
Parameters Details
x = label top (in dot
rows)
Accepted Values:
-120 to 120
Default Value: a value must be specified or the command is
ignored