Specifications

213
ZPL Commands
^KD
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
^KD
Select Date and Time Format (for Real Time Clock)
Description The ^KD command selects the format that the Real-Time Clock’s date and time
information presents as on a configuration label. This is also displayed on the Printer Idle
LCD control panel display, and displayed while setting the date and time.
Format ^KDa
This table identifies the parameters for this format:
Comments If the Real-Time Clock hardware is not present, Display Mode is set to 0
(Version Number).
If Display Mode is set to 0 (Version Number) and the Real-Time Clock hardware is present,
the date and time format on the configuration label is presented in format 1.
If Display Mode is set to 0 (Version Number) and the Real-Time Clock hardware is present,
the date and time format on the control panel display is presented in format 1.
Parameters Details
a = value of date and
time format
Accepted Values:
0 = normal, displays Version Number of firmware
1 = MM/DD/YY (24-hour clock)
2 = MM/DD/YY (12-hour clock)
3 = DD/MM/YY (24-hour clock)
4 = DD/MM/YY (12-hour clock)
Default Value:
0