Specifications

ZPL Commands
~JS
206
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
The value for this command is also reflected in the Backfeed parameter on the printer
configuration label.
For ~JSN — the Backfeed parameter is listed as DEDAULT
For ~JSA — or 100% the Backfeed parameter is listed as AFTER
For ~JSB — or 0% the Backfeed parameter is listed as BEFORE
For ~JS10 — 10% of the backfeed takes place after the label is cut or removed. The
remaining 90% takes place before the next label is printed.