Specifications

199
ZPL Commands
^JM
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
^JM
Set Dots per Millimeter
Description The ^JM command lowers the density of the print—24 dots/mm becomes 12,
12 dots/mm becomes 6, 8 dots/mm becomes 4, and 6 dots/mm becomes 3.
^JM also affects the
field origin (
^FO) placement on the label (see example below).
When sent to the printer, the
^JM command doubles the format size of the label. Depending on
the printhead, normal dot-per-millimeter capabilities for a Zebra printer are 12 dots/mm (304
dots/inch), 8 dots/mm (203 dots/inch) or 6 dots/mm (153 dots/inch).
This command must be entered before the first
^FS command in a format. The effects of ^JM
are persistent.
Format ^JMn
This table identifies the parameters for this format:
Comments If
^JMB is used, the UPS MaxiCode bar code becomes out of specification.
Parameters Details
n = set dots per
millimeter
Accepted Values:
A = 24 dots/mm, 12 dots/mm, 8 dots/mm or 6 dots/mm
B = 12 dots/mm, 6 dots/mm, 4 dots/mm or 3 dots/mm
Default Value:
A
Example • This example of the affects of alternating the dots per millimeter: