Specifications

ZPL Commands
^CT ~CT
118
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
^CT ~CT
Change Tilde
Description The ^CT and ~CT commands are used to change the control command prefix.
The default prefix is the tilde (~).
Format ^CTa or ~CTa
This table identifies the parameters for this format:
Parameters Details
a = change control
command
character
Accepted Values: any ASCII character
Default Value: a parameter is required. If a parameter is not
entered, the next character received is the new control command
character.
Example • This is an example of how to change the control command prefix from a ^ to a ~:
^XA
^CT+
^XZ
+HS