Specifications

115
ZPL Commands
^CM
9/15/06 ZPL II Programming Guide 45541L-004 Rev. A
^CM
Change Memory Letter Designation
Description The ^CM command allows you to reassign a letter designation to the printer’s
memory devices. If a format already exists, you can reassign the memory device to the
corresponding letter without forcing, altering, or recreating the format itself.
Using this command affects every subsequent command that refers to specific memory
locations.
Format ^CMa,b,c,d
This table identifies the parameters for this format:
Comments If two or more parameters specify the same letter designator, all letter
designators are set to their default values.
It is recommended that after entering the
^CM command, ^JUS is entered to save changes to
EEPROM. Any duplicate parameters entered reset the letter designations back to the default.
If any of the parameters are out of specification, the command is ignored.
Parameters Details
a = memory alias for
B:
Accepted Values: B:, E:,R:, A:, and NONE
Default Value: B:
b = memory alias for
E:
Accepted Values: B:, E:,R:, A:, and NONE
Default Value: E:
c = memory alias for
R:
Accepted Values: B:, E:,R:, A:, and NONE
Default Value: R:
d = memory alias for
A:
Accepted Values: B:, E:,R:, A:, and NONE
Default Value: A:
Example • This example designates letter E: to point to the B: memory device, and the
letter
B: to point to the E: memory device.
^XA
^CME,B,R,A
^JUS
^XA