User's Manual

ZEBRA CONFIDENTIAL: INTERNAL USE ONLY ZEBRA TECHNOLOGIES 8
FCC
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF exposure
compliance.
ISED
The products are compliant with SAR for general population/uncontrolled exposure limits in IC RSS-
102 and has been tested in accordance with the measurement methods and procedures specified in
IEEE 1528.
Le produit est le respect de SAR pour la population générale / limites d'exposition incontrôlée de
CNR-102 et a été testé en conformité avec les méthodes et procédures de mesure spécifiées dans
la norme IEEE 1528.
4.Label and compliance information:
Label of the end product:
FCC
The host product must be labeled in a visible area with the following "Contains FCC ID:
UZ7HFDOCK".
The end product shall bear the following 15.19 statement: This device complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
ISED
The final end product must be labeled in a visible area with the following: “Contains transmitter
module IC: 109AN-HFDOCK”.
5.Information on test modes and additional testing requirements
This module has been approved under stand-alone configuration.
The information on how to configure test modes for host product evaluation for different operational
conditions for a stand-alone modular transmitter in a host, versus with multiple, simultaneously
transmitting modules or other transmitters in a host can be found at KDB Publication 996369 D04.
6.Additional testing, Part 15 Subpart B disclaimer
Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment
authorizations (e.g. SDoC) of the host product to be addressed by the integrator/manufacturer.
This module is only FCC authorized for the specific rule parts listed on the grant, and the host
product manufacturer is responsible for compliance to any other FCC rules that apply to the host
product as being Part 15 Subpart B compliant.