User Manual
Table Of Contents
- About This Document
- Contents
- Introduction
- Getting Started
- Print Operations
- Determining Printer Configuration
- Thermal Printing
- Modes of Printing
- Print Media Types
- Replacing Supplies
- Adjusting the Print Width
- Adjusting the Print Quality
- Media Sensing
- Printing on Fan-Fold Media
- Printing with Externally Mounted Roll Media
- Fonts and Your Printer
- Stand Alone Printing
- Sending Files to the Printer
- Print Meter
- EPL Line Mode
- Printer Options
- Control Panel Operation
- Maintenance
- Troubleshooting
- Appendix
Printer Options
Label Dispenser Option
46
980611-001 Rev. B GX420d User Guide 6/4/08
3. Insert the label liner between the dispenser door and the printer body.
4. Close the dispenser door.
5. Press the Feed button to advance the media.
6. During the print job, the printer will peel off the backing and present a single label. Taking
the label from the printer to allow the printer to print the next label. Note: If you did not
activate the label taken sensor to detect the removal of the dispensed (peeled) label with
software commands, the printer will stack and eject peeled labels.