User Manual
Table Of Contents
- About This Document
- Contents
- Introduction
- Getting Started
- Print Operations
- Determining Printer Configuration
- Thermal Printing
- Modes of Printing
- Print Media Types
- Replacing Supplies
- Adjusting the Print Width
- Adjusting the Print Quality
- Media Sensing
- Printing on Fan-Fold Media
- Printing with Externally Mounted Roll Media
- Fonts and Your Printer
- Stand Alone Printing
- Sending Files to the Printer
- Print Meter
- EPL Line Mode
- Printer Options
- Control Panel Operation
- Maintenance
- Troubleshooting
- Appendix
71
Maintenance
Cleaning
6/4/08 GX420d User Guide 980611-001 Rev. B
Sensor Cleaning
Dust can accumulate on the media sensors.
1. Gently brush away dust; if necessary, use a dry swab to brush away dust. If adhesives or
other contaminates remain, use an alcohol moistened swab to break it up.
2. Use a dry swab to remove any residue that may be left from the first cleaning.
3. Repeat steps 1 and 2 as required until all residue and streaks are removed from the sensor.
.
Black-Line
Sensor
Gap
Sensor
Label Taken
Sensor