Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
89
Troubleshooting
Status Light Descriptions
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Application User Interface
With the printer power on, press and hold the feed button. Continue holding the feed
button until the status indicator flash sequence occurs. The next flash sequence occurs
after completion of the previous flash sequence. The flash sequences perform the
following functions:
Printer status is also reported during normal operation when an error occurs, or a status
request can be sent to the printer via the Windows driver. Refer to the Software integrator
Guide for error codes reported by the Windows driver.
Table 7-2 • Application User Interface
Status Flash
Sequence
Action
One Flash, then Solid
Green
Appears for one second. This will print an internal self-test
page.
Two Flash, then Solid
Green
Appears for one second. Performs system calibration – must
be started with paper out of presenter and from under
printhead, and with no error signaled.
Three Flash, then
Solid Green
Appears for one second. Performs a simulated USB cable
connect and reconnect causing a USB plug-and-play event to
occur.
Four Flash, then Solid
Green
Appears for one second. Sets all printer settings to the default
with the exception of media guide calibration, then it will
perform the media guide calibration.
Five Flash, then Solid
Green
Appears for one second. Prints a 50% gray pattern, ejects it
and then prints a diagonal line pattern and ejects it.
If the feed button remains pressed after the five flash sequence, the status light goes off.