Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
7
Troubleshooting
Status Light Descriptions
Application LED States
Immediately after power is applied to the printer, a brief self test is performed and the
status light will report the following conditions:
Table 7-1 • Application LED States
Solid Green 0 - OK
This code is reported when no other
codes are active. It indicates the
printer is functioning normally.
One Red Flash
1 - Paper Jam in
Presenter
This code indicates that media is stuck
in the presenter. This error is set when
the printer attempts to eject the media
but cannot complete the operation.
This error is cleared by removing the
media from the presenter sensor.
Two Red Flashes 2 - Cutter Jam
This code indicates that the printer
could not find the cutter blade or could
not properly manage its position. The
error is set when the printer attempts
to cut but fails after three retries. This
error is cleared by cycling the power
off and on.