Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
83
Accessories
Using other Accessories with the Large Media Roll Adapter
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Using other Accessories with the Large Media Roll Adapter
Universal Roll Holder
The universal roll holder (page 70) can be attached to either side of the large media roll
adapter. Additionally, the media roll low sensor (page 69) can still be used in this
configuration (see "Routing Cables with the Large Media Roll Adapter" on page 84).
1. Attach the mounting block to the large media roll adapter as shown using the two
screws .
2. Attach the universal roll holder to the mounting block with the screw .
Note • Printer not shown attached for clarity.