Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
77
Accessories
Printer Power Supply – 808099-004
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Attaching the Power Supply
1. Make sure the printer’s power supply is turned off. Or if you are using the optional
power supply accessory shown in the illustration below, make sure the power supply’s
AC power cord is unplugged. Note the printer does not have an integrated power
switch.
2. Insert the 24 VDC power supply’s power connector into the printer’s power receptacle.
Verify the power plug’s latch has locked to the connector by giving it a slow gentle pull.
3. Insert the AC power cord into the power supply. Plug the other end of the cord into an
appropriate AC electrical outlet. The active power light will go on if power is on at the
AC outlet.
4. With the power supply on and connected to the printer, the printer’s power status
indicator will light up green. The printer will begin the printer initialization process
which takes approximately 25 seconds. The printer will test the cutter and check for
the presence media. The status indicator will be green if media is loaded and flashing
red (single blink) if media is not loaded.
Note • Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-
C13 connector are used at all times. These power cords must bear the relevant
certification mark of the country in which the product is being used.
Figure 6-31 • Attaching Power
Printer Power
Connector
Plug Varies
by Country
Active Power Light
Printer
Optional Power Supply
Accessory
IEC 60320 C-13 Plug (70W)
AC
Power
Cord