Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
Accessories
Printer Power Supply – 808099-004
76
P1016701-001 Rev. B KR403 Hardware Integrator Guide 9/24/2010
Printer Power Supply – 808099-004
The KR403 power Supply accessory can easily be incorporated into a kiosk design. The
power supply is easily attached to the kiosk with tie wraps.
The power supply has been tested to work with the KR403 printer and complies with all of
the same safety and compliance regulations.
See "Attaching Power" on page 34 for a simple power connection illustration.
• Output voltage: 24 VDC
• 70 Watts, 90-264 VAC at 47-63 Hz
• Peak Power 330 Watts
• Input Current: 1.5 Amp max.
• Inrush Current: 40 Amp max.115 VAC or 80 Amp max.230 VAC
The DC power filter and cable
length is a minimum of 174 mm
EMI Power Filter
Power ON LED