Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
Accessories
Accessories Overview
62
P1016701-001 Rev. B KR403 Hardware Integrator Guide 9/24/2010
• Media Roll Low Sensor — Optical sensor designed to mount into the Roll Support
accessory or other KR403 printer mounting accessory and plug directly into the
rear of the printer.
• Universal Roll Holder — This versatile mounting accessory supports three roll
positions with the ability to mount it on either side of the printer.
• Printer Mounting Plate (for roll holder mounted below printer) — This mounting
plate assembly is designed to work with the Universal Roll Holder accessory when
the roll is in the Low and Under holder positions. It includes a inertia dampening
spring roller to optimize printer performance when using the large 250 mm
diameter rolls.
• Wall Mount Roll Holder — The wall mount supports a maximum media roll
diameter of 150 mm. The wall mounting bracket attaches at the front of the printer
flush to the kiosk wall.
• Printer Power Supply (70 watts) — This printer accessory has been optimized for
use with thermal printers and in particular your KR403 printer. It has been
designed and tested to meet or exceed most international safety and compliance
standards. Please check for more detailed safety and compliance information for
the printer and this power supply at the Zebra Web site: www.zebra.com
• USB Cable – This accessory has been thoroughly tested for use with the 2824
Plus printer.
• Large Media Roll Adapter and Mounting Plate – Designed for use with the printer
when using large (200mm) media rolls to prevent excessive pulling force by the
feed motor.