Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting

59
Media
Printing a Test Receipt
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Printing a Test Receipt
Before you connect the printer to your computer, make sure that the printer is in
proper working order.
You can do this by printing a test (printer
configuration) receipt.
1. Make sure the media is properly loaded and
Ready with the printhead closed. Then, turn the
printer power on if you have not already done
so. If the printer initializes with the status light
blinking green (pause mode), press the Feed
button once to set the printer in Ready (to print)
mode.
2. Press the Feed button to print, present and
removal of receipts two to three times to allow
the printer to calibrate the printer for the
installed media. The printer may feed several
extra receipts during this process if media
calibration needs to be adjusted (this is an
automatic printer feature).
3. When the status light is solid green, press and
hold the Feed button until the status light flashes
once.
4. Release the Feed button. A printer
configuration receipt will print (example shown)
The configuration status receipt will print as two or
more receipts if the receipt size is not large enough
to contain all of the status information as shown
above.
Figure 5-30 • Test Receipt