Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
Media
Preparing a Media Roll for Use
54
P1016701-001 Rev. B KR403 Hardware Integrator Guide 9/24/2010
Preparing a Media Roll for Use
1. Orient the roll as shown below.
2. Tear off a full turn of paper from the new roll.
Caution • This is important since the outer end of the paper is usually fixed to the roll with
some type of glue or self-adhesive substance that might otherwise cause paper jam or
even print head damage.
Figure 5-24 • Paper Roll Orientation
Figure 5-25 • Full Turn Paper Removal
Temperature-sensitive
coating
SW96074C
1
SW96075C
2
Glue or similar
substance