Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
51
Media
Media Guide - Required Accessory
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
3. Insert the media guide under the printhead. Insert the T-shaped tab of the media guide
into the “T”-hole, slide it forward, and fasten the screw. The screw is pre-installed at
the factory on the printer. One is included in the bag with the media guide in case the
screw is damaged or lost. Many times, the installer will only need to loosen the
attached screw.
4. Close the printhead. Push down on the push-bar to securely latch the printhead
closed.
5. Re attach the printer’s power if needed.
Figure 5-23 • Media Guide Installation