Datasheet

Media
Media Guide - Required Accessory
50
P1016701-001 Rev. B KR403 Hardware Integrator Guide 9/24/2010
Media Guide - Required Accessory
For the printer to operate correctly, at minimum you must order and install at least one of
the four (4) media guides listed below.
A printer evaluation kit is available for the KR403 printer that includes all four media
guides.
Installing the Media Guide
The media guide configures the printer to one of four (4) common roll paper widths: 58, 60,
80, or 82.5 mm. The printer senses which media guide is installed and adjusts the default
print width to match it automatically: narrow (58 or 60 mm) or wide (80 or 82.5 mm). The
printer is delivered without a paper guide installed.
Caution • Before proceeding, always disconnect the printer from power. If the printer is
installed in the kiosk, then all kiosk power should be turned off. This is to prevent
accidentally having the screw or media guide bracket fall into the printer or other powered
up kiosk components. The screw or bracket may fall and bounce into kiosk components
mounted adjacent to or mounted below the printer.
1. Select the media guide that matches the width of the media you want to use for your
application. Loosen or remove the media guide screw, if present.
Note • Media guides are ordered separately. Only the KR403 Demo Kit (P1021954)
contains all input guides available for the KR403.
2. Open the printhead by pushing green printhead release push-bar back towards the
rear of the printer and lift up the printhead.
Figure 5-22 • Media Guide
Width (mm) Part Number Width (mm) Part Number
58 09170-058-3 80 09170-080-3
60 09170-060-3 82.5 09170-082-3