Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
37
Connections
Connecting the Printer to the Host
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Refer to Figure 4-14. On the USB / Ethernet configuration , the USB connection is to
the left of the ethernet connection. On the USB / Serial configuration , the USB
connection is to the right of the serial connection.
When using a USB cable (not supplied with your printer), verify that the cable or cable
packaging bears the “Certified USB™” mark to guarantee USB 2.0 compliance.
The figure below displays the cable wiring required to use the printer’s USB interface.
For printer supported operating systems and to download the latest driver, visit the Zebra
printer web site at:
http://www.zebra.com
Figure 4-14 • USB Connection
Pin Signal
1Vbus - N/C
2D-
3D+
4 Not connected
5 Ground
Shell Shield / Drain Wire
Pin 1