Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
35
Connections
Attaching Power
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
DC Power Plug Requirement
The KR403 printer uses a locking two pin connector. The mating connector is Tyco part
number 1445022-2. The wiring for this connector and to meet the power requirements
should be 20 AWG insulated wiring (UL type 1007).
Electrostatic Discharges and Earth Currents
The printer should have a dedicated earth ground connection. Preventing ESD and earth
currents from affecting the printer operation requires proper connection to the printer
chassis via a 12 AWG wire to protective earth.
The ground wire should be connected to the printer as follows:
1. Using a #8 Torx driver, remove the screw shown.
2. Attach the 12 AWG ground wire with cable lug to the printer chassis.
3. Connect the other end of the ground wire to a protective earth ground.
Figure 4-12 • Power Plug
+24 VDC
Ground
Figure 4-13 • Grounding