Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
19
Printer Overview
Design Your Own Mounting
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Design Your Own Mounting
The illustration below gives an example of a printer-mounting shelf.
Additional space is required for paper loading and service access. Consider mounting the
printer on a movable platform so that the printer can be maintained outside the printer
enclosure.
Note • We recommend making the output slot 97 mm wide. This width should
accommodate all paper widths that the KR403 printers can handle.
Caution • NEVER use screws that go into the printer more than 4 mm! This will damage
the electronics inside.
Figure 3-10 • Printer Mounting
20 mm
Paper width
+ 10 mm
44 mm
10 mm
12 mm
6.5 mm
10 mm
90.8 mm
132 mm
156 mm
Leaf spring
01473-000
11 mm
10 mm
1.
5
m
m
Add material for corner radius
Min. 100 mm
Center
10 mm