Datasheet
Table Of Contents
- Introduction
- Design Overview
- Printer Overview
- Basic Printer Dimensions
- Printer Orientation
- Printer Features
- General Printing Information
- Basic Printer Mounting (printer only)
- Design Your Own Mounting
- Print Modes
- Looping Presenter (Kiosk Mode)
- Vertical Presenter (Kiosk Mode)
- Receipt (Page) Imaging Modes
- Controls, Indicators, and Sensors
- Sensing, Status and Error Reporting
- Feed Button Modes
- Printer Configuration Methods and Tools
- Fonts and Your Printer
- Connections
- Media
- Accessories
- Accessories Overview
- Nozzle Bezel – P1011185
- Shutter Bezel – 104591
- Small Core Media Adapter – G105156
- Quick-Fit Hubs – 103939
- Quick Fit Leaf Spring Retainer – 01473-000
- Roll Support – P1014124
- Media Roll Low Sensor
- Universal Roll Holder – P1014125
- Printer Mounting Plate – 104208
- Wall Mount Roll Holder – P1014123
- Printer Power Supply – 808099-004
- Universal Serial Bus (USB) Cable – P1027715
- Large Media Roll Adapter – P1026858
- Mounting Plate for Large Media Roll Adapter – P1027728
- Using other Accessories with the Large Media Roll Adapter
- Routing Cables with the Large Media Roll Adapter
- Troubleshooting
17
Printer Overview
Basic Printer Mounting (printer only)
9/24/2010 KR403 Hardware Integrator Guide P1016701-001 Rev. B
Basic Printer Mounting (printer only)
The printer can only be mounted to the kiosk using the four printer mounting screw holes
shown in the illustration below. The printer is most secure when using all four of the
mounting positions connecting the printer’s base to a rigid metal base plate in the kiosk.
The kiosk’s metal printer mounting plate should be connected to the kiosks electrical
(earth) ground for purposes of controlling static discharge and electrical noise.
For information on ordering accessories, refer to "Contacts" on page 2.
Figure 3-8 • Printer Mounting
Table 3-5 • Mounting Configuration
Mounting Positions Kiosk’s Print Base Mounting Variation Details
and
Full coverage of printer’s
base plate
• Minimum mount positions.
• Supports the Quick-Fit Hubs
• Supported by most Zebra
accessory mounting solutions.
and
Partial (and Full) coverage
of the printer’s base plate
• Minimum three point mounting
to fight torsional forces.
and and