Operation Manual

4 - 8 ET5X User Guide
Using the CS4070
A CS4070 can be used with the ET5X to capture bar code data. The CS4070 must first be paired to the ET5X
before using.
1. Aim the scanner at the bar code.
2. Press the scan (+) button.
Figure 4-11 Scanning
3. Ensure the aiming dot is centered on the bar code.
The scanner beeps and the LED turns green to indicate a successful decode.
Deleting Bar Codes
In batch mode, to delete a bar code aim the scanner at the bar code and press the delete ( - ) button.
NOTE Only one CS4070 can be paired with the ET5X at a time.
NOTE The scanner cannot scan bar codes when it is connected to the host via the USB host cable.
NOTE Hold down the + button for 10 seconds to toggle the beeper functionality on and off.