Operation Manual

Getting Started 4 - 5
Figure 4-5 RS507 Hands-Free Imager
Refer to the RS507 Hands-free Imager Product Reference Guide for more information.
Using the RS507 Hands-free Imager
An RS507 Hands-free Imager can be used with the ET5X to capture bar code data. The RS507 must first be paired
to the ET5X before using.
To read a bar code, a scan-enabled application is required.
1. Launch a scanning application.
2. Point the RS507 at a bar code.
Figure 4-6 Bar Code Scanning with RS507
3. Press and hold the trigger.
The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within the area formed by the
cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
The RS507 LEDs light green, a beep sounds to indicate the bar code was decoded successfully. Note that
when the RS507 is in Pick List Mode, the RS507 does not decode the bar code until the center of the crosshair
touches the bar code.
NOTE Only one RS507 can be paired with the ET5X at a time.