Quick Reference Guide

14 ET51/56 Enterprise Tablet
Handheld Devices
This device was tested for typical body worn operation. Use only Zebra tested and approved
belt-clips, holsters, and similar accessories to ensure FCC Compliance. The use of third-party
belt clips, holsters, and similar accessories may not comply with FCC RF exposure compliance
requirements, and should be avoided.
To satisfy US and Canadian RF exposure requirements, a transmitting device must operate with
a minimum separation distance of 0 cm or more from a person's body.
Pour satisfaire aux exigences Américaines et Canadiennes d'exposition aux radio fréquences,
un dispositif de transmission doit fonctionner avec une distance de séparation minimale de 0 cm
ou plus de corps d'une personne.
Laser Devices
LED Devices
Classified as ‘EXEMPT RISK GROUP’ according to IEC 62471:2006 and EN 62471:2008.
Pulse duration: CW.
Batteries
Taiwan - Recycling
EPA (Environmental Protection Administration) requires dry battery
producing or importing firms in accordance with Article 15 of the Waste
Disposal Act are required to indicate the recycling marks on the
batteries used in sales, giveaway or promotion. Contact a qualified
Taiwanese recycler for proper battery disposal.
Battery Information
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of batteries
according to instructions.
Use only Zebra approved batteries. Accessories which have battery charging capability are approved
for use with the following battery models:
• Model: AMME3735 (7.6 VDC, 3,300 mAh) for 8.4" ET51AE, ET56BE
• Model: AMME3950 (7.7 VDC, 4,950 mAh) for 10.1" ET51AT, ET56BT
• Model: BT-000393 (3.8 VDC, 6,350 mAh) for 8.4" ET51CE, ET56DE
• Model: BT-000394 (3.85 VDC, 9,550 mAh) for 10.1" ET51CT, ET56DT, ET56ET.
Zebra approved rechargeable battery packs are designed and constructed to the highest
standards within the industry.
However, there are limitations to how long a battery can operate or be stored before needing
replacement. Many factors affect the actual life cycle of a battery pack, such as heat, cold, harsh
environmental conditions and severe drops.
When batteries are stored over six (6) months, some irreversible deterioration in overall battery
quality may occur. Store batteries at half of full charge in a dry, cool place, removed from the
equipment to prevent loss of capacity, rusting of metallic parts and electrolyte leakage. When
storing batteries for one year or longer, the charge level should be verified at least once a year
and charged to half of full charge.
Replace the battery when a significant loss of run time is detected.
MN-003332-04ENa_et51-56-qsg-en.fm Page 14