User Manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- About This Guide
- Getting Started
- Using the Tablet
- Wireless
- Data Capture
- Expansion Back
- RS507/RS507X Hands-Free Imager
- RS6000 Bluetooth Ring Scanner
- DS3678 Digital Scanner
- Imaging
- Scanning Considerations
- Scanning with the SE4710 Expansion Back
- Scanning with SE4750 Expansion Back
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 USB Scanner or DS3678 Bluetooth Scanner
- Pairing Bluetooth Scanners
- Connecting a USB Scanner
- Accessories
- Maintenance and Troubleshooting
- Specifications
- Index
Accessories
62
Installing the Insert
Install the tall insert when using a device without a Rugged Frame or Expansion Back. Install the small insert
when using a device with an Expansion Back and without a Rugged Frame.
1. Align the insert over the pins.
Figure 55 Align Insert with Cradle
2. Press the insert down until it seats flush in the cradle.
Charging the Device
To charge the device in the Communication and Charging Cradle:
1. Open the bottom access door and hold it to the back of the device.
2. Align the device with the alignment pins on the cradle.
3. Insert the device into the cradle. Note that the Communication and Charging Cradles contains a locking
mechanism that locks the device to the cradle.
NOTE: Ensure the device is flat on the cradle and all charging contacts are touching the charging base.