User Manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- About This Guide
- Getting Started
- Using the Tablet
- Wireless
- Data Capture
- Expansion Back
- RS507/RS507X Hands-Free Imager
- RS6000 Bluetooth Ring Scanner
- DS3678 Digital Scanner
- Imaging
- Scanning Considerations
- Scanning with the SE4710 Expansion Back
- Scanning with SE4750 Expansion Back
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 USB Scanner or DS3678 Bluetooth Scanner
- Pairing Bluetooth Scanners
- Connecting a USB Scanner
- Accessories
- Maintenance and Troubleshooting
- Specifications
- Index
Data Capture
52
Place the RS507/RS507X or RS6000 in HID or SPP Mode
You may pair the RS507/RS507X or the RS6000 scanner with the tablet using either Human Interface Device
(HID) or Serial Port Profile (SPP) mode:
1. Place the scanner in HID mode or SPP mode using steps “a” through “e” below. If the scanner is already in
HID or SPP mode, skip to step 2.
a. Remove the battery from the scanner.
b. Press and hold the Restore key.
c. Install the battery onto the scanner.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
e. Scan the appropriate barcode below to place the scanner in HID or SPP mode.
Figure 41 RS507 Bluetooth HID Barcode
Figure 42 RS6000 Bluetooth HID Barcode
Figure 43 RS507 Bluetooth SPP Barcode
Figure 44 RS6000 Bluetooth SPP Barcode
2. Perform a Cold Boot by removing and re-installing the battery onto the scanner. The device starts to
operate and is discoverable as a Bluetooth serial device (like a Camera).
Place the DS3678 in HID or SPP Mode
1. You may pair the DS3678 scanner with the tablet using either Human Interface Device (HID) or Serial Port
Profile (SPP) mode:
2. Remove the battery from the scanner.
3. Replace the battery.