Operation Manual

Bar Code Capture with Integrated Camera
Procedure:
1 Ensure that an application is open on the ET1 and a text field is in focus (text cursor in a text field).
2 Aim the rear-facing camera at a bar code.
3 Press and hold either Scan/Action button. By default, a preview window appears. The Decode light emitting diode
(LED) lights red to indicate that data capture is in process.
Figure 35: Sample Scan Application with Preview Window
4 Move the ET1 until the bar code is centered.
5 The Decode LED lights green, a beep sounds and the ET1 vibrates, by default, to indicate the bar code was
decoded successfully.
6 The captured data appears in the text field.
Bar Code Capture with CS3070 Bluetooth Scanner
The CS3070 Bluetooth scanner captures bar code data, and transmits it to the ET1 via Bluetooth. The scanner
supports Bluetooth human interface device (HID) connection to the ET1 where the scanner emulates a keyboard, as
well as Serial Port Profile (SPP) connection where the scanner behaves as if there is a serial connection. See the ET1
Enterprise Tablet Integrator Guide for setup and configuration information.
54 | Data Capture
February 2015 | MN000022A02-A