Operation Manual

Figure 32: Bar Code Scanning
3 Press and hold either Scan/Action button.
The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within the area formed by the
cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
The Scan/Decode LED lights red to indicate that scanning is in process, then lights green, a beep sounds and the
ET1 vibrates, by default, to indicate the bar code was decoded successfully. Note that when the ET1 is in Pick List
Mode, the ET1 does not decode the bar code until the center of the crosshair touches the bar code.
Figure 33: Aiming Pattern
Figure 34: Pick List Mode with Multiple Bar Codes in Aiming Pattern
4 Release the scan button.
5 The captured data appears in the text field.
Data Capture | 53
MN000022A02-A | February 2015