Operation Manual

WAN Activation
Note: ET1N2 only.
In order to use the WAN radio for data communication, the ET1N2 must be activated on the service provider’s
network. By default, the ET1N2 is configured for a GSM network. To activate on a CDMA network, manual
configuration is required.
Refer to the ET1 Enterprise Tablet Integrator Guide for detailed WAN configuration information.
GSM Activation
When the ET1N2 turns on it automatically configures for the network. If the SIM card requires a PIN, the PIN screen
appears. Enter the PIN and touch OK.
CDMA Activation
Prior to using the ET1N2 on a CDMA network, the ET1 must be registered with the service provider. Contact the
service provider to set up an account and provide the MEID number (located under the battery).
By default, the ET1N2 is configured for a GSM network. To activate on a CDMA network:
Procedure:
1
Touch
.
2 Touch More....
3 Touch Mobile networks.
4 Touch Technology preferences.
5 Touch Network mode.
6 In the Network mode menu, select either Sprint or Verizon. The ET1 switches the modem firmware and the
Activation Dialog box appears.
Figure 5: Activation Screen
7 Touch Activate. The ET1N2 begins the activation process. If the activation is unsuccessful, contact the service
provider.
Replacing the Battery
Caution:
Do not remove the microSD card while in Battery Swap mode.
Ensure that the Battery Swap mode procedures are followed, otherwise the backup battery will deplete
quickly and on the ET1N2, SIM card data corruption might occur.
Getting Started | 21
MN000022A02-A | February 2015