Specifications

O Com mand - Hard ware Op tions
C = En able op tional La bel Liner Cut ter.
The cut ter will cut at the end of each
form as spec i fied by the Q com mand.
Cp
1
= Batch Print La bels and Liner Cut.
p
1
= Sets the num ber of la bels to print
prior to cut.
If a num ber be tween 1 - 255 is spec i fied
for p
1
, the printer will cut af ter the spec -
i fied num ber of la bels have been
printed.
If b is spec i fied for p
1
, the “batch print
& cut” fea ture is en abled. This fea ture
uses the P com mand to con trol cut ter
op er a tion.
S = Re verse the Transmissive (Gap) Sen -
sor Op er a tion.
Examples: O :dis ables all op tions.
OC :en ables cut ter only, la bels are cut af ter each
:la bel is printed, dis ables all other op tions
OD :en ables di rect ther mal mode on ther mal trans fer
:print ers, dis ables all other op tions
OCb :la bels are cut af ter a batch of five has printed,
… :dis ables all other op tions
P5 :Sets the num ber of la bels to print be fore the cut
980352-001 Rev.D 3-85